There are many people who are worried of not getting enough water on their bathtubs. Actually, they just need to check how to fix bathtub drain stopper without even placing anything on the drain. You want to fix the problem right from the source and this is what this guide teaches you of.
For you to get started, you must prepare the tools on how to fix bathtub drain stopper such as the following:
- Slotted screw that will be used in removing the so-called “trip lever plate”
- A flexible retriever for you to fish out the brass plunger
- If the problem is more on reattaching the brass plunger on its threaded rod, the pliers are optional
When you have prepared for these tools, you can now proceed to the process on fixing the bathtub drain stopper:
- Remove the trip lever plate with the use of the slotted screw.
- Pull the threaded rod straight up and just pull everything away. If ever the plunger was left inside the trip lever hole, you can now use for the retriever to fish it out.
- Check the entire threaded rod. If the plunger has detached from the rod, you can use the pliers in putting it back on its place. And, tighten the link where it is placed. Aside from the plunger, check the other links if they are bound up. This is one of the common parts to be attended. When you can straighten up the bound up links, you will notice that it can extend the length of the rod for about quarter inch.
- If the threaded rod still looks short, you can now adjust the lock nuts by loosening the lock nut below the plastic adapter. This way, you can spin or turn the plastic adapter down to lower the connecting links to the plunger. After this, tighten the lock nut that is left above the plastic adapter just to put it in place.
- When all parts of the threaded rod are tightened, the plunger can be tested in closing the drain. Put everything back in the trip lever hole. Screw in the trip lever plate securely in order that everything works well.
- After the plate is screwed back in place, let some water run down and check whether the water is not moving right through the drain. If it doesn’t go through the drain, then the drain stopper should be fixed.
As you will observe, the plunger is responsible in stopping the water from getting drained completely. Whenever you pull the trip lever up, you let the plunger down the drain hole. And then, the water no longer comes out of the drain pipe. And when you push it down, it will raise the plunger and let the water out.
Whether the plunger is left in the hole or the threaded rod has the problem, you will also face an issue with the amount of water collected on your bathtub. So, it is best for you to check the threaded rod and plunger. And then, learn the right way of fixing the bathtub drain stopper.